Relay Drive Set-up
The "OUT" test is accessed via the AT Editor software and
can be placed anywhere in a program cycle (Figure 6).
The AT Editor software allows an "OUT" test to be placed
anywhere in the program cycle.
Selection of the six relay drives is easy.
Simply click the left mouse button over the ON or OFF button on any of the
six drives required and click OK.
Activating a relay to add a component will require two
One to close the relay and introduce the component and another to open the
relay and remove the component once the test requiring this component has
Activating an enable output (and/or a program cycle
indicator) would require the "OUT" test set-up in the appropriate area of
the program in order to output the required event.